3-16
www.nemalux.com | [email protected] | Tel 403•242•7475 | Fax 403•243•6190
MADE IN CANADA
TM
Nemalux
I N D U S T R I A L
AR Series
rev. A-30
5.0in
126mm
5.2in
132mm
21.1in
535mm
22.5in
570mm
0.5in
12.7mm
0.3in
6.8mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
STEP 1.
Inspect shipping package and contents to ensure no damage
has occurred during shipping.
STEP 2.
Remove 8x M6 hex cap bracket mounting screws from head
and re-install with included Surface/Suspension Mount
Brackets. See diagram for orientation of brackets. Torque M6
bolts to 5 Nm (45 in-lbs).
STEP 3.
A) For surface mounting configuration, mount luminaire in
desired ceiling location using 4x 1/4-20 OR 4x M6 fasteners
and washers (Not provided). One mounting hole on each
bracket is keyed to allow partial pre-installation of two
fasteners for ease of install.
B) For ceiling mounting configurations, connect 4x anchors to
the 12.7mm (0.5”) holes. Suspension hardware (Not provided)
must be rated for a minimum of 180 lbs.
STEP 4.
Open AR Lens with a 7mm socket or wrench and
allow Lens to hang via retention strap.
Note:
Screws are captive fasteners and will remain attached to the
Lens for ease of reinstall and to prevent loss of fasteners.
STEP 5.
Make wiring connections from branch circuit conductors to
factory provided lead wires. Refer to NEC/CEC codes and
follow all applicable local standards. See wiring diagram on
Page 4.
AR-SM – SURFACE/CEILING MOUNT INSTALLATION
(Ordered Separately)
(All brackets are ordered separately)
Refer to alternate instructions if using, Hook, Wall, Pole or Yoke Mount
Step 5
Step 2
Step 3A
Step 3B
WARNING:
The AR Head must not face
upwards by any degree
beyond the vertical position
for Class II, Division 2,
Zone 22, and Class III
hazardous locations.
LIGHT BEAM
HORIZON
ATTENTION:
Le luminaire (AR) ne doit pas
être orientée vers le haut de
quelque degré que ce soit
au-delà de la position verticale
pour les emplacements
dangereux de Classe II,
Division 2, Zone 22 et Classe III
