NEFF B59FS3A 0 Series, Руководство пользователя и инструкции по установке

Страница: 37 / 60

Troubleshooting
en
37
Fault Cause and troubleshooting
The operation does
not start or is inter-
rupted.
Different causes are possible.
▶
Check the notifications that appear on the display.
→ "Displaying information", Page 14
Malfunction
▶
Call the after-sales service.
→ "Customer Service", Page 39
Appliance does not
heat up.
Demo mode is switched on.
1.
Disconnect the appliance from the power supply for at least 30 seconds by switching off
the fuse.
2.
Switch off demo mode in the basic settings within approx. 5 minutes.
→ "Changing basic settings", Page 23
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a
The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
▶
Change the basic setting for the clock.
→ "Basic settings", Page 22
Home Connect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
The control panel
cannot be opened.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Call the after-sales service.
→ "Customer Service", Page 39
2. If there is water in the water tank, empty the water tank:
‒
Open the appliance door.
‒
Grip on the right and left below the control panel.
‒
Slowly pull out the control panel and push it upwards.
Intense steam gener-
ation when steaming.
The appliance is automatically calibrated.
No action required.
If the cooking times are too short, the appliance is not automatically calibrated.
If a lot of steam is generated repeatedly, the appliance is recalibrated.
1.
Reset the appliance to the factory setting.
→ "Basic settings", Page 22
2. Repeat the calibrations.
→
"Before using for the first time", Page 12
The appliance re-
quests descaling
without the counter
appearing in ad-
vance.
The set water hardness range is too low.
1. Descale the appliance.
→
"Descaling", Page 28
2. Check the water hardness and set this in the basic settings.
→ "Basic settings", Page 22
The appliance
prompts you to rinse
it.
During the descaling, the power supply is interrupted or the appliance is switched off.
▶
Rinse the appliance.
→ "Descaling", Page 28
"Fill water tank" ap-
pears in the display
even though the wa-
ter tank has been
filled.
The water tank has not clicked into place.
▶
Insert the water tank correctly so that it engages in the holder.
→ "Filling the water tank", Page 15
The water tank has fallen out. Shaking has caused parts to come loose in the water tank.
The water tank is leaking.
▶
Order a new water tank.
→
"Customer Service", Page 39