NEFF B59FS3A 0 Series, Руководство пользователя и инструкции по установке

Страница: 15 / 60

Steam
en
15
2.
Set the required type of heating.
→ "Setting the type of heating and temperature",
Page 14
3.
Set the required cooking time depending on the
type of heating.
→ "Cooking time", Page 19
4. Use "Ready at" to set the time at which the opera-
tion should end.
→
"Delayed start/"Ready at" time", Page 19
5. Place the food in the cooking compartment before
the appliance starts to heat.
6. Press to start the operation.
a
The display shows the start time. The appliance is in
standby mode.
a
Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
7. When the operation has ended, remove the food
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Note: If necessary, change the basic setting for the
lighting again.
9 Steam
Food can be cooked particularly gently using steam.
You can use the special types of steam heating, or use
steam assistance with certain types of heating.
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
▶
Open the appliance door carefully.
▶
Keep children at a safe distance.
9.1 Before using the steam function
Before using the steam function each time, make sure
that your appliance is supplied with sufficient water.
Filling the water tank
WARNING ‒ Risk of fire!
Due to the hot surfaces, vapours from flammable li-
quids may catch fire in the cooking compartment (ex-
plosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
▶
Do not pour flammable liquids (e.g. alcoholic drinks)
into the water tank.
▶
Only fill the water tank with water or with the descal-
ing solution we have recommended.
WARNING ‒ Risk of burns!
The water tank may heat up while the appliance is in
operation.
▶
Wait until the water tank has cooled down from the
previous operation.
▶
Remove the water tank from the tank recess.
Requirement: The water hardness is set correctly.
1. Press ⁠.
a
The control panel pops out automatically.
2. Pull the control panel towards you with both hands
and then push it upwards until it clicks into place ⁠.
3. Remove the water tank from the tank recess ⁠.
4. Press down on the water tank lid along the seal to
prevent water from leaking out of the water tank.
5. Remove the cover on the water tank.
6. Fill the water tank with water up to the "max"
mark.
7. Put the cover back into the opening on the water
tank.