Necta Vending Solutions SpA Sfera, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 68

27
© by NECTA VENDING SOLUTIONS SpA 0404 211- 02
CHANGING THE NUMBER OF TRAYS
The vending machines are supplied with 6 trays.
It is however possible to bring the number of trays to 5,
proceeding as follows:
- Disconnect the plug from the power supply.
- Remove all trays from the machine.
- Move the guides (see Fig. 22) placed on the side
supports, except the first ones at the bottom which stay
in the same position.
- Remove the pair of guides not used.
- Replace the 5 trays, ensuring that the connectors are
inserted properly.
- Secure the removed cables, as not to be in the way of
other trays and cables.
- Reprogram the machine.
Fig. 22
1 - Tray connector
2 - Tray guide
TILTING TRAYS
Each tray is fitted with a system of levers (Fig. 23)
permitting tilting downwards to facilitate loading.
In the positions where it is more convenient to keep the
tray horizontal, it is sufficient to lock the system of levers
with a screw.
Fig. 24
1 - Tray
2 - Mobile walls
3 - Right-hand spiral
4 - Left-hand spiral
Fig. 23
1 - Tilting trays lever
2 - Lever locking holes (horizontal trays)
CHANGING THE TRAY CONFIGURATION
The configuration of the spirals on each tray can be
changed. To go from two selections with single spirals to
one selection with double spirals, do as follows:
- Remove the centre wall, pushing it towards the back
and then lifting.
- Remove the spirals, and the flanges, from the two
motors.
- Disconnect the left-hand side motor from the cable and
remove it from the tray. In its place, fit the bush and pin
bush.
- Install the right-hand and left-hand spirals with the
same pitch onto the new flanges (right and left are
identical), fitted with a cogged wheel, and then connect
the right-hand one to the motor still on the tray and the
left-hand one onto the previously installed bushes. The
two cogged wheels must mesh.