28 (E)
STARTING TO SEW
The machine will be set to sew straight stitch
when power switch is turned on.
CAUTION: To prevent accidents.
While sewing, special care is required around
the needle.
As machine automatically feeds the fabric, do
not pull nor push fabric.
A. START AND END OF SEAM
1. Check the presser foot [Regular Foot (A)].
Refer to page 6 for changing the presser
foot.
2. Place the fabric under the presser foot and
lower the presser foot.
3. Hold back upper thread (N424E) or
hold back both threads (N422E, N420E),
and press the start/stop button or press the
foot controller pedal.
Keep holding thread(s) after sewing a few
stitches.
Lightly guide the fabric while sewing.
You can regulate the sewing speed by
sliding the speed control button.
Also, you can reduce the sewing speed by
pressing the slow button.
4. When you reach end of seam, press the
start/stop button to stop sewing or release
the foot controller pedal.
- Model N424E -
5. Press the thread cutter button.
6. Raise the presser foot lifter and remove the
fabric.
- Model N422E, N420E -
5. Raise the presser foot lifter.
6. Remove the fabric and cut threads with the
thread cutter, back to front.
Upper Thread Sensor
If upper thread is broken or missing,
machine will stop automatically.
Rethread the upper thread and resume
sewing.
Model N424E 1
Model N422E 1
Model N420E 01
- Model N424E ONLY -
CAUTION
1. Do not press the thread cutter button when there is no fabric in the machine or no need to
cut the threads. The thread may tangle, resulting in damage.
2. Do not use the thread cutter button when cutting thread thicker than #30, nylon thread or
other speciality threads. In this case, use the thread cutter located on the left side of the
machine. (See page 9)
- N424E -
- N422E, N420E -
Model N424E
Model N422E, N420E
