27 (E)
D. THREADING THE NEEDLE EYE
CAUTION: To prevent accidents.
Do not rotate the hand wheel when threader
lever is lowered.
Note:The needle threader is used for needle
sizes 11/80 - 16/100 and thread sizes 50-
100.
1. Pull thread from needle bar therad guide
until front of extension table.
Lower the presser foot.
NOTE; Check that the needle is raised.
If it is not so, raise needle by pressing
needle up-down button.
2. Lower the threader lever.
Lever will stop at lower position.
The threader will turn and the hook pin will
go through the needle eye.
3. Draw thread through thread guide (a) and
pull toward the right.
4. Draw thread into the guide(b).
Thread will be hooked to the (c).
5. Hook the thread to the thread cutter from
back to front. Pull and cut thread.
6. Lower the lever once more and release
the lever. Hook will turn and pass thread
through needle eye while making a loop.
7. Pull thread out about 10 cm from needle
eye.
E. DRAWING UP THE BOBBIN THREAD
1. Raise the presser foot.
2. Hold thread loosely and press needle up-
down button twice from up position.
The hand wheel will turn one complete
turn.
3. Pull upper thread lightly. Bobbin thread
will come up in a loop.
4. Pull both upper and bobbin threads about
10 cm toward the back of presser foot.
a
b
c
