6 (E)
EXTENSION TABLE
a. REMOVING THE EXTENSION TABLE
Hook your finger to the left bottom side of
extension table and slide it to the left. To
attach, insert to the right.
b. OPENING THE ACCESSORY CASE
Hook your finger to the this side of
accessory case and pull toward you.
CHANGING THE PRESSER
FOOT
The presser foot must be changed according
to the stitch you sew, or work you do.
CAUTION: To prevent accidents.
Turn off the power switch before you change
the presser foot.
A. Changing the presser foot
1. Turn the hand wheel toward you until the
needle is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the
presser foot release lever toward you.
4. Place desired foot with its pin directly
under the slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
B. Removing the presser foot holder
When cleaning around the feed dog or
attaching extra foot (option), you may
remove the presser foot holder.
1. Remove the presser foot.
2. Loosen the presser foot thumb screw and
remove the presser foot holder.
3. To replace the holder, pull up the holder
as far as it will go from bottom of presser
bar.
4. Tighten the thumb screw.
