CHAPTER 4 EQUIPMENT DESCRIPTION
UNIVERGE NEAX 2000 IPS General Description
Page 94
Issue 5
Common Control Cards (Cont.)
Abbrev
Name Code
Remarks
MP
PN-CP31-D
Main Processor Card (DMR)
Provides LAN control function, System-based Device Registration
Server (DRS), built-in FP, 33 MHz PCI BUS, Memory (SDRAM 32
MB, Flash ROM 9 MB), TDSW (1024CH × 1024CH), 16-line CFT,
PB sender, Clock, 2-line PLO (receiver mode/source mode), one
RS-232C port, 4-line PB receiver, internal Music-on-Hold tone,
BUS interface. BUS interface functions as a driver/receiver of
various signals, adjusts gate delay timing, cable delay timing,
monitors I/O Bus and PCM BUS.
Supports MP Program Download (FTP download for stand alone
mode only).
One card is required per system.
ETHER
PZ-M606-A
Ethernet Control Card
Mounted on MP card to accommodate the Ethernet and
transmit/receive a signal of TCP/IP protocol. Provides Auto
Negotiation function.
• Set to ON/OFF by the office data setting
[For Series 3400 software or later]
10 BASE-T/100 BASE-TX twisted pair cable is connected directly
to this card.
FP
PN-CP15
Firmware Processor Card
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-
module BUS interface. BUS interface functions as a driver/receiver
of various signals, adjusts gate delay timing and cable delay
timing, monitors I/O Bus and PCM BUS. When the system consists
of three PIMs or more, one each of this card is mounted
respectively in PIM2, PIM4, and PIM6.
ETHER PZ-M697
(for DML)
Ethernet Control and inter-module BUS interface Card Mounted on
PN-CP31-E card to accommodate the Ethernet and
transmit/receive a signal of TCP/IP protocol.
Provides Auto Negotiation function.
– Set to ON/OFF by the office data setting.
10BASE-T/100BASE-TX twisted pair cable is connected directly to
this card. BUS interface functions as a driver/receiver of various
signals, adjusts gate delay timing and cable delay timing, monitors
I/O Bus and PCM BUS.
Occupies two physical slots width per card on PN-CP31-E card.
FP
PN-CP33
(for DML)
Firmware Processor Card
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-
module BUS interface. BUS interface functions as a driver/receiver
of various signals, adjusts gate delay timing and cable delay
timing, monitors I/O Bus and PCM BUS. When the system consists
of three MCs or more, one each of this card is mounted
respectively in the MP slot of MC2, MC4, and MC6.
Содержание UNIVERGE NEAX 2000 IPS
Страница 43: ...CHAPTER 2 SYSTEM CONFIGURATION UNIVERGE NEAX 2000 IPS General Description Page 39 Issue 5...
Страница 44: ...CHAPTER 2 SYSTEM CONFIGURATION UNIVERGE NEAX 2000 IPS General Description Page 40 Issue 5...
Страница 86: ...CHAPTER 3 TERMINALS UNIVERGE NEAX 2000 IPS General Description Page 82 Issue 5...