NEC SuperScript 1800, Руководство пользователя

Страница: 56 / 131

50 SuperScript 1800 Series — User’s Guide
O
PERATOR
P
ANEL
T
ASKS
This section describes important tasks you perform using the
Operator Panel buttons and menu selections.
Taking the Printer Offline and Online
Press the Go/Continue button to switch between the online
and offline states.
note:
The printer must be offline before you can change
any printer settings. It must be online to print.
While the printer is offline, it continues to receive data until
its input buffer is full. If you press the Go/Continue button
while the printer is printing, it finishes the current page, and
then waits for you to bring it online again.
Setting Media Type
When you load a new paper type into the tray, you should set
the Media type. By default the printer is set to handle
medium weight (16–28 lb) paper. If you do not specify the
correct media type print quality may be poor because the
printer will move the paper at the wrong speed. To change
the Media type, on the Operator Panel press the Go/
Continue
button to take the printer offline. Then, press the
Menu button to display
JOB MENU
. Then press the Item
button to display
P-TYPE PLAIN
. Press the Value button to
display
THICK
or
THIN
. Choose the correct paper type and
press the Select button, then the Go/Continue button to
bring the printer online again.
note:
Choose “Thin” only if you are using 16lb. paper in
high heat (90.5° F / 32.5° C) or humidity (over 80%)
weather conditions.
Stopping a Print Job
If you wish to stop a print job before it is complete, simply
press the Cancel button while the printer is online.
Cleaning the Fuser Unit
If random spots are appearing on the back of your print outs
use the following steps to clean the internal fuser unit.
1.
Press Go/Continue .
OFFLINE
appears on the display.
2. Press Menu until
SERVICE MENU
appears on the display.
3. Press Select until
FUSER CLEAN
appears on the display.
4. Press Select and the printer will print out a double-sided
page. The panel displays
READY
.
Restoring Factory Defaults
To restore factory default settings to the printer
1.
Press Go/Continue .
OFFLINE
appears on the display.
2. Press Menu until
JOB MENU
appears on the display.
3. Press Item until
FACTORY SETTINGS
appears on the
display.
4. Press Select and
READY
appears on the display. All
settings will be reset to factory defaults. The page
counter will be not be reset.