NEC NEC Express5800 Series, Руководство пользователя

Страница: 307 / 580

Troubleshooting 8-11
Error message after power-on
Displayed Error Message Description Recommended Action
8001 Real time clock error Real-time clock error
8002 Check date and time
settings The real-time clock time
setting is incorrect.
Start up the BIOS setup
utility, and then specify the
correct date and time. If the
same error continues to
occur, contact your service
representative.
8003 System battery is dead -
Replace and run SETUP
There is no system battery. Contact your service
representative to request
battery replacement. (After
the replacement, start up the
BIOS setup utility, and then
specify the correct settings.)
8005 Previous boot incomplete
- Default configuration
used
The last time the system was
started up, POST processing
did not finish. Use the BIOS setup utility to
specify the correct settings.
8006 System configuration
data cleared by Jumper.
The BIOS setup utility
settings were cleared using
the jumper. Specify the BIOS setup utility
settings again.
8007 SETUP Menu Password
cleared by Jumper.
The BIOS setup utility menu
password was cleared using
the jumper. Use the BIOS setup utility to
specify another password.
8010 Graphics controller was
not detected.
No graphics controller was
detected.
8800 DXE_NB_ERROR
An error was detected during
chip set initialization.
8801 DXE_NO_CON_IN
8802 DXE_NO_CON_OUT
An error was detected during
console initialization.
8803 PEI_DXE_CORE_NOT_
FOUND
8804 PEI_DXEIPL_NOT_FOU
ND
8805
DXE_ARCH_PROTOCO
L_NOT_AVAILABLE
A Flash ROM failure was
detected.
8806 PEI_RESET_NOT_
AVAILABLE
8807 DXE_RESET_NOT_
AVAILABLE
The system was not reset
correctly.
Contact your service
representative.