NEC N8100-1078F, Руководство пользователя

Страница: 206 / 332

8-24 Troubleshooting
The following message appears on the screen and the setup is suspended while the Express
Setup is executing:
Bad Command or filename
Insufficient disk space
→
Follow the procedure described below and check the BIOS settings for the SCSI
controller.
As for the procedure on the SCSI controller which is not described in this User's
Guide, refer to the manual accompanied with the controller and check the setting for
"Int13 Extensions".
<In case the SCSI Controller is AIC-7892>
1. Press Ctrl + A when POST displays "AIC-7892".
2. Select "Configure/View Host Adapter Settings".
3. Select "Advanced Configuration Options" and press Enter .
4. Change the setting of "BIOS Support for Int13 Extensions" to "Enabled".
5. Exit from BIOS setup menu and restart the system.
6. Start the Express Setup.
Unable to specify the details of Network adapter.
→
In Express Setup, you can not specify the details of Network adapter. Specify them
from Control Panel after starting Windows 2000.
Windows 2000 is started with Network adapter that has not been specified during Express
Setup
→
Windows 2000 will install the recognized Network adapter specified as default value.
If you want to modify the specification, it can be done from Control Panel after
starting Windows 2000. Also, the Network adapter that has been specified during
Express Setup but that is not connected will not be setup, though the protocol will
only be installed.
Connected more than two Network adapter and specified different protocol for each adapter,
but all the protocols are specified on either adapter.
→
It's a design. Each adapter is specified so that all the installed protocols can be used.
The value that can not be specified during Express Setup will all be specified by
default value.