Safety Guide [IP8800/S6300]
xxxix
damaged by the static electricity.
■
After removing an optional component, be sure to attach a blank panel.
• After removing an optional component, be sure to attach a blank panel. Using the device without the blank
panel attached, the air flow in the device cannot be maintained. In such a case, the temperature rise inside the
device may cause a failure.
■
Be sure to install the network interface module with the tray attached.
• Be sure to install the network interface module (NIF) with the tray attached to the device. If the NIF is inserted
without the tray attached, the connector of the NIF may not fit the connector of the switch, and the connectors
of both side may be damaged.
■
Attach an option component with care.
• Follow the following procedures to attach an option component. Otherwise, a problem may occur on the device.
1. Open the levers as the figure below.
2. With the levers in hands, push the component slowly into the device, to the point where the levers touch the device.
3. Use the levers to insert the component all the way. Move the levers slowly (taking more than one second) but not forcedly.
■
Before removing an optional component, loosen the screws completely.
• Use levers to remove the management and switching unit or network interface module. If screws are not
completely loosened, the optional component may be damaged when the levers are pressed down.
■
When carrying or packing an optional component, take care for handling.
• Take care not to handle the connector when carrying or packing optional components such as the management
and switching unit, network interface module, memory card, transceiver, and power supply. They must be
stored in antistatic bags when they are not in use.
■
Do not install the device in any place possibly reaching a high temperature.
• Be careful that the parts may be damaged if left in a place exposed to direct sunlight or close to a heating
apparatus.
Содержание IP8800/S2400 Series
