NEC IP8800/S2400 Series, Руководство по устранению неисправностей

Страница: 217 / 250

6.
Line Test
155
> no test interfaces gigabitethernet 1/1 [Enter]
> activate gigabitethernet 1/1 [Enter]
IP8800/S3600 and IP8800/S2400
A case of test conducted on Port 1 of NIF 0 at a transmission interval of one second is shown as a test example.
Execute the
test interfaces
command and the
no test interfaces
command in this order from the
operation terminal.
> inactivate gigabitethernet 0/1 [Enter]
> test interfaces gigabitethernet 0/1 internal [Enter]
(Wait about 1 minute.)
> no test interfaces gigabitethernet 0/1 [Enter]
> activate gigabitethernet 0/1 [Enter]
As the command execution result, the screens shown in " Figure 6-2: Execution Result Example of the
test
interfaces
command and the
no test interfaces
command [IP8800/S6700] [IP8800/S6600] [IP8800/
S6300] ," the
no test interfaces
command [IP8800/S6700] [IP8800/S6600] [IP8800/S3600] , " Figure
6-3: Execution Result Example of the
test interfaces
command and the
no test interfaces
command
[IP8800/S3600] [IP8800/S2400] ," and the
no test interfaces
Command [IP8800/S3600] [IP8800/2400]
are displayed. Check the following:
"Send-NG" and "Receive-NG" are 0.
If "Send-NG" and "Receive-NG" are 0, the line test result is acceptable.
If "Send-NG" and "Receive-NG" are not 0, some abnormality exists. See the display contents of the line test execution
result in the manual "Operation Commands."
If "Send-NG" and "Receive-NG" are not 0 for 10GBASE-R, re-execute the line test and check if "Send-NG" and
"Receive-NG" are 0. If "Send-NG" and "Receive-NG" are not 0, some abnormality exists. See the display contents of
the line test execution result in the manual "Operation Commands."
Figure 6-2: Execution Result Example of the test interfaces command and the no test interfaces
command [IP8800/S6700] [IP8800/S6600] [IP8800/S6300]
> inactivate gigabitethernet 1/1
> test interfaces gigabitethernet 1/1 internal interval 2 pattern 4
> no test interfaces gigabitethernet 1/1
> activate gigabitethernet 1/1
Date 2006/03/10 00:20:21 UTC
Interface type :100BASE-TX
Test count :12
Send-OK :12 Send-NG :0
Receive-OK :12 Receive-NG :0
Data compare error :0 Out underrun :0
Out buffer hunt error :0 Out line error :0
In CRC error :0 In frame alignment :0
In monitor time out :0 In line error :0
H/W error :none