i-Series Gateway
Page 11
G-6000G-SKE, Rev AA
6\QFKURQRXV6HULDO'HYLFH593B'LUHFW
Introduction
This section of the guide provides the necessary information to configure the i-Series
Gateway for connection to a synchronous-serial device. The units are programmed at
the factory with “default” settings providing basic parameters to accommodate many
network environments.
Figure 4. RVP_Direct Typical Installation
Prerequisites for Configuration
Both units must be installed properly and the network link between both devices must be operational.
Basic Configuration
Table 5. RVP_Direct Configuration Steps
You must ….……
to…………
Default settings
Refer to System
Administrator’s Guide
Set the Telephone Port
compression algorithm
for all active telephone
ports.
Provide adequate bandwidth
for all users.
ADPCM 32 (on
all telephone
ports)
Chapter 4 - Port set up,
Setting Voice
Parameters, page 61.
Enable/Disable WAN
ports
Enable WAN ports to
connect to network device.
WAN 1 - Enabled
Chapter 4 - WAN set up,
page 72.
Set the Sync Rate of the
WAN port.
Match the data rate (sync
rate) of the network device.
512,000 kbps
Chapter 4 - WAN set up,
page 74.
Set the mode (interface
type) of the WAN port
(v.35, RS-232, RS-530).
Match the interface type of
the network device.
V.35
Chapter 4 - WAN set up,
page 80.
Increase Jitter Delay
(for Frame Relay and
Async installs only).
Match network
characteristics of the Frame
Relay network.
0
Chapter 4 - Setting Voice
Parameters; page 62.
P unch Block
Public
D S U /C S U
D SU /C S U
PBX
B ranch O ffice
C orporate Facility
Punch Block
i-Series G atew ay
i-Series 6000
Extender
R outer
R outer
