![background image](http://html1.mh-extra.com/html/nec/express5800-r320c-e4-n8800-173f/express5800-r320c-e4-n8800-173f_installation-manual_4200244106.webp)
4. Setting Up Windows Server 2008 R2
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows)
106
Chapter 1 Installing Operating System
4.1.2
Preparation
The following steps are required to prepare for re-installing an OS (setup with EXPRESSBUILDER or
Winodws standard installer):
1. If the POWER LED on CPU/IO module is on, shutdown the OS.
2. Unplug the power cord from outlet while the POWER LED is blinking.
3. Perform the preparation process for the server as shown below.
–
Install CPU/IO modules 0 and 1.
–
Install a hard disk drive in slot 0 of CPU/IO module 0.
–
Disconnect all LAN cables.
–
Disconnect the cable for tape device from the connector on SAS board.
–
Disconnect the cable for device from the connector on Fibre Channel board.
Important
•
Install only one hard disk drive in the slot specified here.
•
If the hard disk drive is not a new one, physically format it. Refer to
Chapter 3 (3.
SAS Configuration Utility)
in
Maintenance Guide
for physical formatting.
4. Prepare for setup on CPU/IO module 0.
The location of components that are required for setup or confirmation is as shown in the figure below.
Install only one hard disk drive in CPU/IO module 0.
Do not install any hard disk drive in CPU/IO module 1.
Install one hard disk drive
in this slot.
CPU/IO module 0
Status LED
POWER switch
CPU/IO module 1
DISK ACCESS LED
DUMP (NMI)
switch
FRONT