Initial Linux Operating System and Express Builder Installation or Default Reinstallation
Installing the Operating System and Express5800/ftServer System Software
2-9
Figure 2-1. SAS (SATA) Drive Arrangement for Installation
Make sure that the system and monitor power connections are secure and firmly
plugged in before beginning an installation procedure. Power cabling should be
guarded against inadvertent disconnection during the installation process. The
monitor may use a separate power source.
Begin the installation process with both CPU-I/O enclosures inserted and with the
ftServer system halted. A red LED is lit at the left side of each CPU-I/O enclosure.
Ensure that the green power button at the right side of the upper CPU-I/O
enclosure is lit; the lit LED indicates that it is the active (primary) enclosure. If the
upper CPU-I/O enclosure is not the active enclosure, you must make it the active
enclosure by performing the actions listed in step
2
of the installation procedure in
‘‘Initial Linux Operating System and
Express Builder
Installation or Default
Reinstallation’’ on
page 2-10
.
For security during installation and initial configuration, isolate the ftServer system
from networks and other communicating hosts.
Be aware that a system with a newly installed operating system and
Express
Builder
is not
secure until it has been configured. In addition, you may want to change
the default network settings.
Initial Linux Operating System and Express Builder Installation
or Default Reinstallation
The User Guide (Setup) contains detail procedures to install the Linux operationg system
and the ftControl Software.
asys076
sda
sdb
sdc
sdd
sde
sdf
