1. Installing Internal Optional Devices
Express5800/E120d-1 User’s Guide
46
Chapter 2 Preparations
1.3
Overview of Installation and Removal
Install/remove components by using the following procedure.
Installing/removing internal components except for hard disk drives should be done after dismounting the
server from the rack. It is recommended that more than one person removes the server from the rack.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
Do not drop the server
Do not leave the server pulled out of the rack
Replace the cover after installing components
Beware of high temperatures
Do not get your fingers caught when installing components
1.
If the server is mounted on a rack, use the UID switch to identify the target server.
Refer to
Chapter 2 (1.4 Confirming Servers (UID Switch))
.
2.
If the server is ON, turn it off.
Refer to
Chapter 3 (6. Turning Off the Server)
.
3.
Disconnect the power cord from the outlet and the server.
Important After disconnecting the power cord from the server, wait for at least 30
seconds before continuing to work because the components on the
motherboard might still be operating for about 30 seconds even after the
power cord was disconnected.
4.
Pull out the server from rack and put it on a flat rigid desk when installing or removing the components
other than the following two devices:
Refer to
Chapter 2 (2.1 Installation)
for details.
Processor(CPU) PCI
Board
DIMM(Memory) PCI
Controller
Battery for RAID Controller
Important Do not leave the server open on the rack.
When installing a hard disk drive only, go to step 9.
5.
Remove Top Cover.
Refer to
Chapter 2 (1.5 Removing Top Cover)
.
6.
Depending on the components to be installed or removed, follow the procedure in order.
Refer to
Chapter 2
(1.6 Processor(CPU))
to (
1.9 Use of Internal Hard Disk Drives in the RAID System
).
