![background image](http://html.mh-extra.com/html/nec/express5800-120md-series/express5800-120md-series_user-manual_251192087.webp)
Configuring Your System 3-23
C
onfiguring the RAID Controller
The RAID (Redundant Array of Inexpensive Devices) option available for your
system is the three channel SecuRAID 530 (Mylex eXtremeRAID 1100) RAID
controller board, which gives your system the added security of fault tolerance.
If you order a system with an Operating System (OS) hot load and a RAID
controller, the system is pre-configured at the factory according to Table 3-3.
Table 3-3 RAID Configurations
Number of Hard Drives
RAID Level
Configured
Description of RAID Configuration for BSU Drives
1 small and several large
capacity drives
7 on small
capacity
drives
JBOD (RAID 7)
Known as
Just a Bunch of Drives
,
JBOD allows the controller to access the drives
independently. This configuration has no redundancy
and does not use striping.
2 small and several large
capacity drives
1 on the two
small capacity
drives
Mirroring (RAID 1)
Drives are paired and mirrored. All
data is 100% duplicated on an equivalent drive (fully
redundant).
3 or more
same capacity drives
5 on three
capacity
drives
Striping with Parity (RAID 5)
Three drives are striped
and parity is added. Capacity of one drive is redundant
parity.
To complete the RAID configuration or if you want to change the RAID level or
add additional hard disks to the array, use the RAID configuration utility. The
RAID configuration utility is included with the RAID controller.
If you are adding the RAID controller to an existing system, the RAID
configuration utility allows you to configure your disk array before reinstalling
your network operating system. The RAID controllers support various versions
of RAID technology (referred to as RAID levels). To use any RAID level, you
must configure the RAID controller using the RAID configuration utility prior
to installing your Network Operating System. For an explanation of this utility,
refer to the documentation on the MYLEX CDROM that was shipped with the
RAID controller. It describes RAID technology and provides tips on making
your array perform well in your specific application. It also
covers array
hardware preparation, configuration, and initialization. After completing the
steps in the manual, you can install your Network Operating System.
If you want to remotely configure the array (from a PC client); increase array
capacity online; or monitor statistics on disk and controller activity, you must
install the array manager provided with your RAID subsystem. Increasing array
capacity is covered in the user's guide shipped with the option.
Содержание EXPRESS5800/120Md Series
