![background image](http://html.mh-extra.com/html/nec/dt920/dt920_user-manual_248961075.webp)
FEATURE OPERATION
65
3.
Press Answer key.
Feature key lamp goes off.
Answer key lamp goes off.
RECEIVING A VOICE FROM
SPEAKER
It is possible to change the terminal to
“listen-only”
during the call in progress. You can hear the caller's
voice from the speaker on the terminal with putting
the handset on the hook.
TO RECEIVING A VOICE FROM
SPEAKER
1.
Call in progress.
2.
Press Speaker key.
Speaker key lamp lights red.
3.
Replace the handset.
You can hear the voice of calling party from
the speaker.
TO RESTART TALKING
1.
Receiving a voice from the speaker.
2.
Lift the handset.
Speaker key lamp goes off.
TALKING HANDSFREE
Dialing or answering a call is possible without lifting
the handset.
TO SET HANDSFREE
1.
Press Mic key or Soft key (MIC).
Mic key lamp lights red.
TO CANCEL
1.
Press Mic key or Soft key (MIC).
Mic key lamp goes off.
TO MAKE A CALL WITH HANDS FREE
1.
Mic key lamp is going off.
2.
Press Speaker key.
Speaker key lamp lights red.
Line key lamp lights green.
3.
Dial desired number.
4.
The called party answers.
Press Mic key or Soft key (MIC).
Mic key lamp lights red.
Talk toward the mic.
TO ANSWER A CALL WITH HANDS
FREE
1.
The Call Indicator Lamp flashing.
Line key lamp flashes red.
2.
Press Speaker key.
Speaker key lamp lights red.
Line key lamp lights green.
3.
Talk toward the mic.
When you make a call handsfree,
please note the following items.
Avoid using in a place where
there is a lot of echo or
noise.
The Microphone is located at
the front of the terminal. It
should be no further away
than 50 cm.
When talking handsfree, be
aware of the volume level as
to not disturb people close to
you.
Talk alternately with the
other party. The voice may
be interrupted if both party
talk at the same time.
CALL PICKUP - GROUP
This feature permits a terminal user to answer any
calls directed to other extensions in their preset
pickup group.
This feature is set by system data
setting at initial installation. For details,
please contact the system
administrator.