Section 1: Start-up Programming
DS1000/2000 Quick Setup Guide
Section 1: Start-up Programming
◆
1-1
1
Section 1:
Start-up Programming
Section 1: Start-up Programming
Default Feature Setup
This is how your system operates on initial power-up:
Trunks
In DS1000, trunks 1-6 (if installed) ring line keys 1-6 and single line telephones.
●
Trunks 4-6 will only work if you have an Expansion Board installed.
In DS2000, trunks 1-12 ring on line keys 1-12 for extensions 300-315.
●
All other extensions are lamp-only for trunks 1-12 on line keys 1-12.
●
Trunks 13-64 do not appear on line keys.
●
Single line sets do not ring for incoming trunk calls. See
Programming Ringing
on page 1-7.
All trunks (outside lines) on ATRU PCBs are loop start DTMF.
●
If you have Dial Pulse lines, you’ll have to reprogram the trunk circuit type. See
Setting a Trunk’s Cir-
cuit Type
on page 1-7. For T1 trunks, see the
Software Manual
on your
System Document CD
.
Keysets
The circuit types for extensions are automatically set when the extension is plugged in.
Keyset users can place outside calls by pressing a line key and dialing the outside number.
●
Extension users can also place outside calls by dialing 9 plus the outside number.
At the attendant’s extension (300), key 11 is the Night Key and the last key on the phone (12
or 24 - depending on telephone model) is the Operator Call Key.
●
Pressing the Night Key puts the system in the night mode. See
Night Service / Night Ring
on page 2-21.
●
Use the Operator Call Key to answer incoming Intercom calls queued at the attendant’s extension. See
Attendant Call Queuing
on page 2-1.
If you need to modify your system’s default feature setup:
•
First, turn to
Frequently Asked Programming Questions
on the next page.
•
Next, if you can’t
fi
nd the feature you want to change in the list of questions, refer to the
additional features in
Section 2: Customizing Features
on page 2-1. You may also
fi
nd the
Table of Contents at the beginning of this guide a handy reference.
•
Finally, if you need more detailed information, go to the
Software Manual
on your
System
Document CD
.
