NDUSTRIA™ Infrared Electric Manual
9
4.2 Replacing Emmiter/Lamp
Contact your distributor for the correct replacement
emitter, providing the model number and rating from
the rating label. Not using an exact replacement emiit-
ter can cause the heater to fail.
CAUTION:Do not touch emitter/lamp with bare hands.
Wearing soft cotton gloves is highly recommended.
1. Turn power OFF and allow heater and emmiter/lamp
to cool completely before cleaning.
2. Remove the screws from the end of the heater fi x-
ture and remove the aluminum end cap.
3. Carefully slide the perforated front grille immedi ately
adjacent to the end cap off the end of the unit.
4. Carefully slide the protective grille to the end of
the heater to expose the emitter and silicone seal
ing connectors.
5. Carefully remove the emitter and silicone wire con-
nectors from the aluminum emitter clips, free ing the
wire/connector system.
6. Carefully remove the silicone terminal connec tors
from the ends of the emitter. Be careful not to break
the emitter terminal end inside the silicone wire con-
nector. Discard the used emitter.
7. Holding the new emitter by the ceramic ends or
wearing clean dry gloves, place the silicone termi nal
connectors onto the new emitter and re-clip it into the
emitter holder.
8. Carefully slide the protective grille and perforated
end cap into place, and replace screws.
4.3 Service
1. Repairs must be carried out by service specialists to
ensure electrical safety. Contact an authorized ser-
vicer or qualifi ed electrician for service.
2. Improper repairs could result in death or personal
injury to users. USERS SHOULD NOT ATTEMPT TO
MAKE REPAIRS.
3. Do not handle emmiter/lamp/lamp with bare hands.
Remove any fi nger marks with a soft cloth and meth-
ylated spirits or alcohol. Finger marks will burn into
quartz causing premature lamp failure. Outer casing
can reach high temperatures.