NDUSTRIA™ Infrared Electric Manual
8
SECTION 4: MAINTENANCE & SERVICE
Your heater is a robust unit with an aluminum casing
and protective cover, and requires only minimal main-
tenance. There are no user serviceable parts inside
aside from replaceable emitter lamp.
There are only two maintenance procedures which
can be done on location: cleaning the unit and replac-
ing the emitter.
• Service must be performed only by a qualifi ed elec-
trician or service technician.
• Do not use heater if it has been dropped or dam-
aged in any way, until it has been inspected by an
authorized service facility.
• Do not operate any heater after it malfunctions.
• Do not perform service without turning heater OFF
from main power supply.
• To disconnect heater, turn controls to off, and turn off
power to heater circuit at main disconnect panel.
• If power cord is damaged, contact an authorized
servicer or electrician to replace cord prior to use.
• Do not touch heater while in operation. Heater
casing and front cover are extremely hot when in use.
Allow adequate time for the unit to cool down.
• Do not insert or allow foreign objects to enter any
ventilation or exhaust opening.
4.1 Cleaning
When cleaning heater or replacing emitter, follow
these steps:
1. Turn power OFF and allow heater to cool completely
before cleaning.
2. Remove the wire guard and carefully wipe the
refl ector with a soft, lint-free cloth. Never use abrasive
cleaners, scrubbing brushes or chemical cleaners on
heater. Alcohol can be used to clean heater exterior.
Do not immerse cord, plug, or any part of the heater in
water or other liquid.
CAUTION:Do not touch the emitter.Finger marks will
bum into the quartz emitter during use and cause
premature heater failure.
If emitter is inadvertently touched, or if it needs to be
cleaned, carefully wipe it using rubbing alcohol or
denatured alcohol.
Cut/Pinch Hazard
Wear protective gear
during installation,
operation and service.
WARNING
Failure to follow these instructions can result in death, electric shock, injury or property damage.
Burn Hazard
Keep all persons,
especially children,
away from heater.
Do not touch any part
of the heater.
Heater is very hot.
Fire Hazard
Keep all flammable
objects, liquids and
vapors the minimum
required clearances to
combustibles away
from heater.
Some objects will
catch fire or explode
when placed close to
heater.
DANGER
Electrical Shock Hazard
Disconnect electric
before service.
Heater must be
connected to a properly
grounded electrical
source.
