NDS Dometic LSE 105 BF, Инструкция по установке и эксплуатации

Страница: 19 / 352

EN
11. Fix the roof duct, e.g. with adhesive tape, until the adhesive has dried completely (after approx. 12 h) to ensure
that the roof duct rests firmly on the surface of the vehicle.
Note Wait at least 48 h before moving the vehicle.
fig.

on page 6
Mounting the solar panel with rear connection
(LSE 105 BR, LSE 200 BR)
WARNING! Risk of injury
Use a suitable adhesive, e.g. Sikaflex
®
-554. Do not use silicone.
1. Drill a hole into the vehicle surface for the junction box.
fig.

on page 6
2. Apply adhesive to the back of the solar panel. Pay special attention to the side areas and the area around the
junction box.
fig.  on page 7
3. Route the connection cable through the pre-drilled hole into the vehicle interior (
1 , fig.

).
4. Place the solar panel on the prepared bonding surface on the vehicle (
2 , fig.

).
fig.

on page 7
5.
NOTICE! Damage hazard
• Do not press too hard on the surface of the solar panel.
• Ensure that the area around the junction box is well sealed.
Press the solar panel lightly against the adhesive surface to ensure that the solar panel is firmly seated.
Connecting the solar charge controller (accessories)
Observe the following instructions when connecting the solar charge controller:
• Connect the house battery before connecting the solar panel.
• Connect several solar panels only in parallel and up to the rated power of the solar charge controller.
• In the case of two or more batteries, parallel connection is permissible if the batteries are of the same type, ca-
pacity and age. Connect the batteries diagonally.
• Also observe the instructions and safety precautions for the solar charge controller used.
Related documents:
Find the information on installing the solar charge controller (SCE 320, SCE 320B, SCE 360,
SCE 360B) online at
https://documents.dometic.com/?object_id=87660 .
17