33
Document Number
DCV-00545
Date Released
Jul. 2020
Revision Number/Security level
R01 S2
Retrofit OPTIC 5 Touch+ InvencoLink Wayne Ovation (US & Canada)
Installation Guide
To apply the new UPC blank panel (gasket part number MP0527):
1. Apply new gasket, starting with the horizontal segment along
the top edge of the bezel opening. Peel off the backing paper
on this segment only, align the gasket in the gasket channel
and press into place. Take care not to stretch the gasket.
2. Peel off the backing paper on the left vertical segment, align
the gasket in the channel and press into place. The top corner
should be closed and the edges touching.
3. Repeat step 2 with the other vertical channel.
4. Peel off the backing paper on the bottom horizontal segment,
align the gasket in the channel and press into place. The
bottom-right corner should be closed and the edges touching.
The bottom-left corner should be just touching the vertical
segment as shown. A small witness gap is permissible at this
join.
To apply the new printer blank panel (gasket part numbers MP0620 and
MP0621):
1. Apply new gasket MP0620 first, starting with the horizontal segment
along the top edge of the bezel opening. Peel off the backing paper
on this segment only, align the gasket in the gasket channel and
press into place. Take care not to stretch the gasket.
2. Apply the new gasket MP0621 next, by aligning the vertical upper
end to the vertical lower end of the MP0620 to ensure there is no
gap at this joint. Peel off the backing paper and align the gasket in
the channel and press into place.
3. Apply the remaining sections of MP0620. Peel off the backing
paper on the left vertical segment, align the gasket in the channel
and press into place. The top corner should be closed and the
edges touching.
4. Peel off the backing paper on the bottom horizontal segment, align
the gasket in the channel and press into place. Also align with the lower end of MP0621 to
ensure there are no gaps at this joint. The bottom-right corner should be closed and the edges
touching. The bottom-left corner should be just touching the vertical segment as shown.
Note: If you make a mistake with the gasket, it can be gently removed once. If you remove it more than
once the adhesive will fail and a replacement gasket will be needed.
