Chapter 2: Setting Up and Using the Printer
7156 Owner’s Guide
September 1997
26
Paper Low Sensor
The paper low sensor is set at the factory to detect when there are about 4 ½ meters,
±
3
meters (15 feet,
±
10 feet), of receipt paper remaining. The sensor is adjustable to detect less
or more paper remaining. It is recommended, however, that the sensor be kept at the
factory setting.
If the sensor has accidentally been changed, follow these steps to re-adjust it. These steps
will only get the sensor to an approximate position of the factory setting. To have the
sensor reset to the exact setting as the factory setting, a service representative will need to
be called. See “Contacting a Service Representative” in chapter 3.
1. Open the receipt cover.
2. Move the sensor along the cutout until it is as close as you can get it to the middle
notch.
The other two notches are used for paper low settings in other printer configurations
and can be ignored.
3. Close the receipt cover.
Note:
Remember, this is only an approximation of the factory setting.
Содержание 7156
