NCD Explora 450 Series, Инструкция по установке

Страница: 47 / 62

Installing Additional Memory
Installing Optional Equipment in the Monitor Support Base 6-7
Your
NC
already has a
SIMM
or
SIMM
s installed. The
SIMM
slots, located on
the left side of the logic board, are labeled J9 and J10. (See Figure 6-5.) Observe
the
SIMM(
s) currently in the slots and refer to Table 6-1, “Memory
Configurations,” on page 6-2 to determine your configuration. Decide what
you want your new configuration to be. If you need to remove an existing
SIMM
, go to “Removing SIMMs” on page 6-9 and then return to this section
for installation instructions.
Figure 6-5 Location of the SIMM Slots
SIMM slots