NCD Explora 450 Series, Инструкция по установке

Страница: 34 / 62

Installing Additional Memory
5-8 Installing Optional Equipment in the Space-Saver Base
2. As you pull back on the tabs, the
SIMM
pops up past the metal tabs. (See
Figure 5-8.)
3. Hold the
SIMM
on both ends and remove it from the slot.
Reassembling the Space-Saver Base
To reassemble the
NC
, follow these steps:
1. Swing the front of the top section over the front edge of the bottom section
and continue down, placing the hooks on the top section in the slots on the
bottom, as shown in Figure 5-3 on page 5-5.
Note
Make sure the top section is resting completely aligned on the
bottom section before going to step 2.
Hold SIMMs on
edges
Figure 5-8 Removing the SIMM