International LT625
COMPANY CONFIDENTIAL
© 2019 SmartDrive Systems, Inc. This information is intended for use by SmartDrive customers only. Any other use without the express written consent of SmartDrive Systems, Inc. is strictly prohibited.
Rev 5, August 04, 2020
Press the green button on the keypad or driver feedback device 5 times in 10 seconds
to initiate Diagnostic Mode
When diagnostic mode is complete, it will display all Zeros (000000).
Press the green button one time to create a manual event.
Note: The SR4 Controller will reboot after the test is complete.
When the test identifies a SR4 system fault, a code will display on the keypad or the driver
feedback device. Fault codes are cumulative
Example:
Sensor Bar not found (020,000)
Ignition Off (010,000)
____________________________
The error codes are added together. 030,000 will display.
When the keypad displays a fault code, use the SR4 Installation Checklist and Diagnostic
Mode/Fault Code Guide to assist you in resolving the problem. This document is available from
your SmartDrive Project Manager or online in the Response Center help page.
If you can’t resolve a fault code, contact Technical Support.
Toll free number (866) 933-9930 Option 1
Run Diagnostic Mode using the Keypad or Driver Feedback Device
