International LT625
COMPANY CONFIDENTIAL
© 2019 SmartDrive Systems, Inc. This information is intended for use by SmartDrive customers only. Any other use without the express written consent of SmartDrive Systems, Inc. is strictly prohibited.
Rev 5, August 04, 2020
Sensor Bar Installation Details
1. The sensor bar must be visible to the driver. Do not
mount where a visor in the down position or fully
extended can block the drivers view of the sensor bar.
2. Clean the windshield with an alcohol pad and wipe dry
with clean cloth. Do not use shop rags which have
grease even when clean.
3. Remove the baseplate from the sensor bar.
DO NOT lose the screws
4. Press firmly on the baseplate for 10 seconds to ensure
it adheres properly to the windshield
5. Install the sensor bar and secure screws until tight
6. Run sensor bar wires to the controller
7. Ensure the cable does not prevent the functionality of
an airbag
Keypad Installation Details
1. Mount keypad bracket and secure the bracket with 2 self-
tapping screws
2. Run the length of the keypad cable behind the dashboard to
the controller location.
3. If needed, drill a ¾ inch hole in the dash and insert a ¾ inch
snap bushing into the hole to protect the cable from sharp
surfaces
4. Inspect the backside of the box & verify that the screws don’t
protrude and cause damage
5. Insert keypad into mount
Best Practice: Sensor Bar and Keypad Installation Details
See Sensor Bar slide for
location information
See Keypad slide for
location information
