BHM
10/04/18
NTV-DOC265
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
7 |
P a g e
UCTv2 + Programming
Programming the UCTv2 + is performed i
n the vehicle, through the factory dash MUTE button, TUNING KNOB, and
CLUSTER LCD for feedback.
1.
Before attempting to program, after making connections, let the vehicle perform a CAN-reset: Close all
doors/trunk/hood, lock the vehicle and waiting 10 minutes before
proceeding to program.
2.
Turn the vehicle’s ignition on. Be certain you’re resting in
FM mode
(see an FM station frequency on the cluster), otherwise the cluster
information may not display.
3.
Close all doors (
door status may override NAV-TV settings cluster feedback
).
4.
View the chart on the next page for settings descriptions and the diagram above to begin programming.
5.
NAV-TV programming mode will time out (back to factory) after 15 seconds.
Scroll to the end of the settings
menu and select
‘EXIT’
to exit and save settings.
Press and HOLD
(15 seconds) to
enter NAV-TV
settings mode
While in NAV-TV
settings mode only:
Rotate clockwise
(
slowly
, one
detent/time) to
scroll through
options. Press ENTER
to change setting.
To show the FM source on the
cluster
, first clear any messages
shown (door status, etc) with the UP
or DOWN arrows on the steering
wheel. Press the audio source button
until ‘FM’ is displayed.
Center button:
Change Audio Source
