BHM
10/04/18
NTV-DOC265
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
13 |
P a g e
FAQs
Q1. I can’t get into programming
mode.
A1. Turn off the vehicle and remove the key. Close all points of entry and use the remote to lock the vehicle.
Wait approx. 5 minutes without opening or disturbing the vehicle. Unlock and cycle the ignition to the ‘RUN’ position.
Make certain that the cluster is in FM radio mode before you begin programming;
and no errors are displayed (door
open, etc), otherwise the cluster information might not display. Hold down the “MUTE” button until you see the display
options post on the cluster.
Q2. When I try to force (front, rear) camera, nothing happens.
A2. Make certain you’ve enabled the options you want to u
se in the NAVTV settings mode and that you scrolled
to the end
and selected ‘EXIT’ (or it will not save)
.
Q3. I hear no audio when my auxiliary source is playing on screen.
A3. Verify that the audio RCAs are connected properly to the AVSW.
Q4. Everything works properly, but when an audio source is connected to the 3.5mm audio jack,
there’s no audio.
A4. Make sure the audio RCAs are connected together on the Plug & Play harness.
Q5. When I place the vehicle into reverse, I get a black or blue screen.
A5. Make sure the camera is getting sufficient power and the RCA is connected to the proper yellow RCA on the
24-pin harness.
Q6. The camera image is displayed properly when the vehicle is in rev
erse, but there’s only a black or blue
screen
when the camera is forced.
A6. Make sure the camera power is not connected to the reverse lamps. Camera power needs to be connected
to an accessory wire (cigarette lighter). If the camera is OEM, forcing it to display in any gear is
not
supported.
