BHM
10/04/18
NTV-DOC265
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
5 |
P a g e
UCTv2 + Module Installation
1.
After removing the factory radio, grab the provided
Plug & Play T-harness
and connect the female
side to the factory 44-pin plug. Make certain the lock connects together securely.
2.
Install A/V source and run signal/power leads into the front dash opening.
Note:
12v ACC is
provided from
output 1
(PIN 11, white/red).
If connecting any device(s) which draw 1amp or more,
trigger a relay with this output instead powering directly!
3.
Make all connections (RCAs & wired) as shown in diagram below (if adding A/V source only)
OR
page
6 (if adding A/V source
AND
Front camera).
4.
Connect the male side of the
Plug & Play T-Harness
to the main radio display. Proceed to page 9
for programming.
UCTv2 + Install Diagram (adding A/V with OEM tailgate camera)
