© Nauto 2019. All Rights Reserved.
5
Digital multimeter with sharp leads
(or wire piercing leads)
Razor knife
3M Super 33 electrical tape
Wire strippers
(self strippers)
Wire crimpers
(capable of crimping insulated terminals)
Compact cordless 1/4” impact driver with hex drive
#2 Phillips drill bit
Connection Method
Description
Recommended Tools
Poke & Wrap
Requires splicing into a low voltage wire for a connection.
18 AWG nylon butt connectors (2 or 3)
Posi-Tap
Requires posi-tap connectors to tap into wires without cutting or splicing.
Proper sized posi-taps
Solder
Requires a heated tool to bond wires using a filler metal with low melting point.
Soldering iron
Deep 1/4” drive metric sockets
(5.5mm and 7-13mm)
T5 Torx driver with handle
Trim panel removal tool
8” or 11” black zip/nylon ties
18 AWG ring terminals
#6 x 1/2” self tapping screws
Installation Tool List
The following tools are recommended to perform installation of the Nauto Device:
The following tools are recommended based on the preferred connection method:
