Nautel VR-Link, Техническое руководство по эксплуатации

Страница: 32 / 58

Page 3-6
VR-Link Technical Instruction Manual
Issue 0.6 Section 3 Operating Instructions
Figure 3-6: Configure Inputs Menu
3.4.2. Remote Panel Configuration
This section describes how to configure
the Netburner for use with ECMPs. If
there are ECMPs connected to
ECMPA ,
ECMPB , or ECMPC at the back of the
VR-Link, disconnect them.
Select the Remote Panels tab (see Figure
3-5). Enable the remote panels and select
Submit . The VR-Link’s internal ECMP, if
installed, will be automatically detected
and listed. If there are no ECMPs, skip to
3.4.2.3.
Connect one external ECMP to the back
of the VR-Link and refresh the Remote
Panels page. The external ECMP will be
automatically detected and listed. Repeat
this for each additional external ECMP.
There are two configuration options for
each ECMP:
•
Inputs are used to configure the
ECMP control switches (see 3.4.2.1).
•
Outputs are used to configure the
ECMP indicators (see 3.4.2.2).
3.4.2.1 Input Configuration
Select Inputs from the Remote Panels
menu on one of the ECMPs. The
Configure Inputs menu (see Figure 3-6)
allows the user to configure any one of the
16 inputs.
While the ECMP’s functions can be
expanded using its parallel connections
(see the ECMP Technical Instruction
Manual), this manual only describes
setting up the preconfigured settings.
Enter a name for the ECMP being
configured in the Panel Name field. This
will allow the user to better identify which
ECMP they are configuring.
By setting the inputs to the appropriate
channel the user will be able to control
that function of the Vector transmitter. The
available Channels include Control
Functions and Control Points.
Refer to the ECMP’s Technical Instruction
Manual to determine which inputs
correspond to the front panel switches.