15
o
Connect the 3/8 OD tubing (supplied) to the quick connect fitting on the outlet of
the Filtration box.
o
Connect the other end of the 3/8 OD tubing to the
Natura
™
Water Refrigeration
unit. To do this, reach inside the top of the unit (the unit is already opened) and
find the coil of tube that has a quick connect fitting with a plug on the end. Feed
the end of this tubing through the 2” diameter hole in the bottom of the unit.
Remove the plug and set aside. Now connect this tube to the one from the
filtration box.
o
Make sure that the tube does not tangle and does not come in contact with any
heat sources.
o
Install the filter sumps in the filtration box.
NOTE:
MAKE SURE THAT THE
PROTECTIVE PLASTIC WRAPPERS ARE REMOVED FROM THE FILTER
CARTRIDGES
! The sediment filter (white) is located on the left. The carbon
filter (black with netting) is located on the right. Make sure that the cartridge
slips down over the stand pipe in the bottom of the sump. Hand tighten – DO
NOT OVER TIGHTEN.
o
When laying out the supplied tubing for installation, if it is necessary to pass the
supply tubing under the platform, it is important to have good tubing protection
to prevent the tube from getting cut. Copper pipes or tubing of the same
diameter before and after the filtration box and to the unit can be used instead
of the plastic tubing supplied.
o
Always use certified plumbing materials for contact with potable water.
WATER SUPPLY
LINE – FROM
MAINS
WATER
VALVE
WATER
PRESSURE
REGULATOR
AND TUBING
ASSEMBLY
FILTER
SET
3/8 OD
TUBING
1/4 OD TUBING
FOR CO
2
CONNECTION
POWER
CORD OUT
BOTTOM OF
UNIT
WATER
REFRIGERATION UNIT
PROVIDED WITH UNIT
PROVIDED WITH UNIT
SCHEMATIC OF INSTALLED UNIT
