10
3.5 Usage Limits
o
Connect to a POTABLE WATER supply only. If the water has high
turbidity or sediment, then install an additional pre-filter prior to the main
filtration box.
o
The unit cannot be used to treat sewage, salt water, chemically
conditioned water, or water with physical or bacterial properties that will
keep the water from being treated effectively.
o
The water dispenser is not designed to operate in excess humidity,
outdoor environments, or in excessive heat environments. Therefore, it is
advised not install or use the unit in the aforementioned environments.
o
On a daily basis, it is important to remove three liters of water from the
tap prior to drinking the dispense water.
3.6 Proper Use of Machine
Use the water purifiers as described in this manual to properly treat
drinking water.
3.7 Improper Use of Machine
Anything not mentioned in point 3.6. Any other use is to be considered
unreasonable and the manufacturer will not respond to subsequent
damages that may arise.
4.
TRANSPORTATION:
A thin plastic protective film covers the external stainless steel casing of the water purifier
units and the filtration box. This protective cover must not be removed until the unit is ready
for installation to avoid any scratches or stain on the surface of the casing. When shipping, it
is important to apply labels with ‘FRAGILE’ warnings on the outsides of the box.
4.1 Transportation and Movement
The Water purifier must always be in a vertical (“ Up”) position when
being transported or moved and handled with special attention due to its
‘Delicate’ nature.
4.2
Storage of the Unit
The unit should not be exposed to a very high humidity condition and
should only be stored in a dry, cool place. Do not stack the units more
than two high without any proper support or protection on the top
surface.
4.3 Unpacking
Cut the banding with box cutter then remove the top and outer sleeve.
Lift the unit off the bottom pad. Peel the protective film off the stainless
steel panels when the unit is in its final location.
