Test Conditions
The following setup conditions are required to ensure the SA1000X meets published
specifications:
■
Allow all test instruments a warm-up time of at least the amount of time
stated in their specifications documents.
■
Allow the SA1000X a warm-up time of at least 30 minutes.
Calibration Overview
Refer to
to determine when you first need to calibrate the
SA1000X.
Complete the following to verify that the performance of your SA1000X is within
specification:
■
■
Required Software for Calibration
■
NI-DMM (PXIe-4082 first supported in NI-DMM 15.2)
■
NI-FGEN (PXIe-5413 first supported in NI-FGEN 17.1)
■
Supported application development environment, such as LabVIEW or
LabVIEW NXG
Verifications
Notice
The connectors on the probe and test equipment are fragile.
Perform the steps in these procedures with great care to prevent damaging
the probe or any test equipment.
ni.com
14
SA1000X Safety, Environmental, and Regulatory Information
