5-30
|
ni.com
Chapter 5
Counters
Figure 5-33.
Finite Buffered Sample Clocked Pulse Train Generation
There are several different methods of continuous generation that control what data is written.
These methods are regeneration, FIFO regeneration, and non-regeneration modes.
Regeneration is the repetition of the data that is already in the buffer.
Standard regeneration is when data from the PC buffer is continually downloaded to the FIFO
to be written out. New data can be written to the PC buffer at any time without disrupting the
output. With FIFO regeneration, the entire buffer is downloaded to the FIFO and regenerated
from there. Once the data is downloaded, new data cannot be written to the FIFO. To use FIFO
regeneration, the entire buffer must fit within the FIFO size. The advantage of using FIFO
regeneration is that it does not require communication with the main host memory once the
operation is started, thereby preventing any problems that may occur due to excessive bus traffic.
With non-regeneration, old data is not repeated. New data must be continually written to the
buffer. If the program does not write new data to the buffer at a fast enough rate to keep up with
the generation, the buffer underflows and causes an error.
Continuous Buffered Sample Clocked Pulse Train Generation
This function generates a continuous train of pulses with variable idle and active times. Instead
of generating a set number of data samples and stopping, a continuous generation continues until
you stop the operation. Each point you write specifies pulse specifications that are updated with
each sample clock. When a sample clock occurs, the current pulse finishes generation and the
next pulse uses the next sample specifications.
Table 5-7.
Finite Buffered Sample Clocked Pulse Train Generation
Sample
Idle Ticks
Active Ticks
1
3
3
2
2
2
3
3
3
S
o
u
rce
O
u
t
Co
u
nter Armed
Sa
mple
Clock
Co
u
nter
Lo
a
d V
a
l
u
e
s
2 1 0 1 0 1 0 1
2 1 0 2 1 0
0
2 1 0 2 1 0 1 0
0 2 1 0 2 1
1
0
3
2
2
2
3
3
3
3
2
3
3
2
