INSTALLATION
1. Install the “P” Clamp onto the stock engine
bar. Flat Side Toward the Outside.
Figure 11
2. Use the stock screws to Re-install the Valve
Cover to motorcycle.
Figure 12
Top of “P” Clamp extends out the top of the
modified Black Cover.
Figure 12
Install the Left Comfort Bar at Lower Mount
Point.
3. Swing the lower section of the Bar through the
open section of the lower plastic.
Figure 13
4. Access the mount point from the front where
horn was removed. Loosely secure in place
using one Screw, M8 x 40 (3), Split Washer (4),
and Washer (12).
(13mm Socket, with Rachet)
Figure 14
Figure 11
Flat Side to
Outside
Figure12
Figure 13
Figure 14
7
12
5
9
6
8
Diagram C
National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / [email protected]
©2019 National Cycle, Inc.
Page 6 of 8
10-110008-000 01/19
Install the Left Comfort Bar at Upper Mount
Point.
5. Refer to Diagram C. Starting with the Rear-
ward Screw (7), make an assembly using
Washer (12) and Protective Sleeve (8).
Diagram C
12
3
4
