National Auto Tools NSS-8000, Инструкция по эксплуатации

Страница: 7 / 13

7
Track Installation
Start with the track with the cylinder. This track will be located with the hose
connection facing out toward the leg with power unit bracket attached.
NOTE The
power unit can be located in two locations shown. With an assistant, pick up and
place one end of the main side track on the crossrail, and then pick up and place
the other end on the opposite crossrail (if you have three assistants, place both
ends at the same time). Use a large screwdriver or aligning punch to align the
mounting holes in the cross rails with the mounting holes in the track.
Do not
leave the tracks unbolted
– install the mounting bolts immediately!
Install
1/2” x 4” mounting bolts and 1/2” washers
thru the ramp brackets and wheel
stops. Make sure the bolt head is on the flat side of the bracket. Install the two
ramp brackets and two wheel stop with bolts and washers as you secure the
main side track to the cross rail. Secure the bolts with 1
/2” washers and nuts
placed hand tight . Now, install the offside track and again secure with ramp
brackets, wheel stops with
1/2” x 4” bolts and nuts
. After both tracks are
installed, tighten all bolts 1/2” x 4” bolts - torque - 45 ft-lbs.
Find the leg caps
(4 each), 1/2” x 7” bolts (4 each), 1/2” x 1 1/4” bolts (4
each), 1/2” nuts (8 each) and 1/2 “ flat washers (16 each),
holes for cable face
towards the center of the lift. Secure the leg caps with
1/2” x 1 1/4” bolts
. Place
the bolts with washers in through channel and secure with washers and nuts on
the outside of the leg. Install the
1/2” x 7 ” bolts through the leg and top cap.
Install from outside of the leg, and secure with a nut on the inside of the leg.
Tighten the
1 1/4” bolt . Tighten the 7” bolt to a torque of 45 ft-lbs. Do not over
tighten the
7” bolt
, as this may warp the column channel and bind the guide
blocks.
1) The cables are already strung and ready to attach to the top of legs. Before
doing this you must extend the chrome rod out of the cylinder far enough for the
cables to reach. If you have the lift on the lowest lock you will need to extend the
cable approximately 60 inches.