National Auto Tools NSS-8000, Инструкция по эксплуатации

Страница: 5 / 13

5
ALWAYS wear safety glasses. Every day eyeglasses only have impact
resistant lenses. They are not safety glasses.
READ AND UNDERSTAND ALL SAFETY WARNINGS & PROCEDURES
BEFORE OPERATING LIFT.
POST THESE SAFETY TIPS WHERE THEY WILL BE A CONSTANT
REMINDER TO YOUR LIFT OPERATOR. FOR INFORMATION SPECIFIC TO
THE LIFT, ALWAYS
REFER TO THE LIFT MANUFACTURER’S MANUAL.
Improper installation can cause accelerated
wear, resulting catastrophic failure which
may cause property damage and / or bodily
injury. Manufacturer will assume no liability
for loss or damage of any kind, expressed
or implied, resulting from improper
installation or use of this product. Read this
installation manual in its entirety before
attempting to install or operate the lift.
SELECTING SITE:
Before installing your new lift, check the following.
OVERHEAD OBSTRUCTIONS
: The area where the lift will be located should be
free of overhead obstructions such as heaters, building supports, electrical lines
etc.
FLOOR REQUIREMENTS:
Visually inspect the site where the lift is to be
installed and check for cracked or defective concrete. This lift must be installed
on a solid level concrete floor with no more than 2 degrees of slope. A level floor
is suggested for proper installation and level lifting. If a floor is of questionable
slope, consider a survey of the site and/or the possibility of pouring a new level
concrete slab. This lift is designed to be installed on a minimum of 4” thick,
3500psi, steel reinforced concrete. Do not install this lift on asphalt, wood, or any
other surface other than described. This lift is only as strong as the foundation on
which it is installed.
DO NOT install this lift outdoors unless special consideration has been made to
protect the power unit from weather conditions.
DO NOT begin installation with lift close to wall. It is necessary to leave adequate
clearance for installing safety linkage rods. Allow 60” for clearance.
(See Fig.1)