NatComm FAXSWITCH 2, Руководство пользователя

Страница: 4 / 20

Natcomm Page 4
OPERATING PROCEDURE
For Traditional Faxswitch method
This method is based on the traditional Faxswitch method, where this unit
will automatically answer ALL incoming calls FIRST after 2 rings. It will
then briefly “listen” to this call for Fax Calling Tones (CNG Tones).
If CNG tones are detected,
FaxSwitch 2
will RING your attached Fax
Device and connect the incoming Fax Call to it.
If CNG tones are NOT detected,
FaxSwitch 2
will RING all of the
telephones attached to the PHONE PORT outlet.
With this mode of operation, you will be able to receive Fax Calls
WITHOUT your telephones ringing first.
Incoming voice calls however will all be answered first by
FaxSwitch 2
a short delay will be experienced by the caller before your telephones
begin to ring.
FaxSwitch 2
will generate a ring, similar to the normal
telephone exchange ring back to your callers until you are able to answer
the line.
Fax calls that are manually dialed (i.e. the caller has dialed your number
but has not pressed the Send key) can be transferred to your Fax device,
from any telephone on your line, by pressing 3 on your telephone. You
should then hang up.
Please Note - With this mode, all telephones connected to your telephone
line must be connected direct to the LINE OUT port of
FaxSwitch 2
. If
you are only using one telephone on your line, or a single Cordless
Telephone system, then you should connect this to the LINE OUT port of
your unit. With this method, if you have other phones located on other
telephone sockets on your line, then you will need to have Professional
Installation.
When used on PBX systems,
FaxSwitch 2
should be installed by an
ACMA approved telephone cabling technician.
DIP SWITCH SETTINGS
If you wish to set
FaxSwitch 2
to operate in this mode, please set :
Dip Switch 1 to the OFF position.