NARGESA MP1400 CNC, Инструкция пользователя

Страница: 45 / 77

INSTRUCTIONS BOOK FOR PRESS BRAKE MP1400 CNC 44
7.4. Gauge position
The position of the stop, of course, is the name given to the parameter responsible for determining the po-
sitioning of the stop point during a bend. Depending on the placement, the folding will result in a more or
less short wing of the metal sheet.
To modify this parameter, once selected, simply enter the dimension value you want to position the stop by
using the numeric keypad. If you enter an invalid value the control system of the Press Brake will not permit
it to be assigned.
Once you've typed in the stop position, to make this is positioned at the desired height, simply by pressing
the button to confirm the entry. If it does, it will stop advancing as quickly but soft to the point of desti-
nation. Of course, if you reach the point and it represents the dimension in which the stopper is currently,
this one will not move.
7.5. Working mode
You must know that making a choice at this point between manual or automatic mode it is just for a diffe-
rence of operation. Thes difference between the two lies in what happens to the ram after performing a
bend.
If you work in automatic mode, after performing folding, just at the moment that take your foot off the pedal
down, the ram automatically rise up to the upper limit previously defined.
If instead you operate in manual mode, upon termination of a bend and release the pedal down, the ram
will remain static. To make it up in this case, you can simply press the pedal up and the upward movement
of the same stops until it reaches the upper limit that has been set before.
>>>
MODE MANUAL PRESS BRAKE
Gauge Distance = 600.0 mm
Descent Speed = Low Speed
Upper Limit = 12000
Lower Limit = 12000
Performing in Manual
INFORMATION
Enter a new gauge distance
and press Confirm.
Gauge =