NARGESA MP1400 CNC, Инструкция пользователя

Страница: 56 / 77

INSTRUCTIONS BOOK FOR PRESS BRAKE MP1400 CNC 55
10.3. Correction of the gauge
To perform the correction of the ram we must follow one by one, the steps shown in the graphic display.
First, you must place the proper die and punch to successfully complete the fit. Then, press the pedal down
until the punch and die fit, and then press the enter button to confirm
At this point, the actual position of the linear encoder absolute 0 of the ram has been edited and stored.
gauge correction menu permits the adjustment of it, ie allows to enter a particular dimension, this is the
actual distance between the gauge and the punch.
The correction of the gauge is, indeed, even easier than the correction of the ram. It is only necessary after
automatic placement of the stop in a dimension of 100.0 mm, enter the new real coordinate using the nu-
meric keypad. I.e. must accurately measure and enter the real coordinate for the fit to be perfect.
Pressing the we will see that a restart of the entire control will occur, which comes to be a necessary
and logical situation. Now the gauge have got the correct correction so it can be worked with normally.
RAM CORRECTION
1.- Place the DIE Number 47
2.- Place Punch Numero 1
3.- Press the Pedal Down
4.- Make the punch coincide with the die
5.- Press the Confirm key
GAUGE CORRECTION
ACTUAL GAUGE POSITION
>>>>> <<<<<
Gauge Positioning...
WARNING!!
With the gauge in this position, measure
actual dimension and insert it. You should
bear in mind that introducing an
erroneous dimension, will cause too few
erroneousgauge positions later on