Napoleon HMF100, Инструкция по установке и эксплуатации

Страница: 39 / 44

W415-1066 / A / 03.06.12
39
7.7 gLASS rEPLACEmENT
¾” x 3 ½”
FLAT
GASKET
¼” ROPE
GLASS
GASKET
SILICONE
DO NOT sUBsTITUTE MATERIALs.
gLAss MAY BE HOT, DO NOT TOUCH gLAss UNTIL COOLED.
CARE MUsT BE TAkEN wHEN REMOvINg AND DIspOsINg OF ANY BROkEN DOOR gLAss OR
DAMAgED COMpONENTs. BE sURE TO vACUUM Up ANY BROkEN gLAss FROM INsIDE THE Ap-
pLIANCE BEFORE OpERATION.
DO NOT sTRIkE, sLAM OR sCRATCH gLAss. DO NOT OpERATE AppLIANCE wITH gLAss RE-
MOvED, CRACkED, BROkEN OR sCRATCHED.
7.9 FILTErS
The furnace must not be operated without filters. in order to efficiently and safely operate a slow combustion
heating system, you have to ensure a regular maintenance. This means that the chimney, the joints and the
flue must be kept in good condition and the air filters must be replaced regularly; use standard capacity pleated
air filters (16” x 12” x 1”) (406 mm X 305 mm X 25 mm).
7.8 CArE OF gLASS (IF EquIPPEd)
if the glass is not kept clean permanent discolouration and / or
blemishes may result. normally a hot fi re will clean the glass.
The most common reasons for dirty glass include: not using
suffi cient fuel to get the appliance thoroughly hot, using green
or wet wood, closing the draft so far that there is insuffi cient air
for complete combustion.
if it is necessary to clean the glass, buff lightly with a clean dry
cloth and non-abrasive cleaner.
DO NOT CLEAN gLAss wHEN HOT! clean the glass after the fi rst 10 hours of operation with a
recommended appliance glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently.
NEvER FORCE IT sHUT!
if the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out and do
not operate the appliance again until the glass has been replaced, available from your Authorized dealer. DO
NOT sUBsTITUTE MATERIALs.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
LA VITRE CHAUDE CAUSERA
DES BRÛLURES.
NE PAS TOUCHER LA VITRE
AVANT QU’ELLE AIT REFROIDI.
NE JAMAIS LAISSER LES
ENFANTS TOUCHER LA VITRE.
!
AVERTISSEMENT
A. When the appliance is cool, remove the door and place it face
down on a soft surface. be careful not to scratch the paint.
B. remove the 5 screws securing the glass retainers.
C. remove all broken glass.
D.
cut the 3/4” flat gasket into 3 1/2” (89 mm) lengths and affix to
glass retainers as illustrated, ensure the gasket extends past
the ends of the retainers by 1/4” (6 mm).
E. Apply small beads of silicone in the gasket groove, as shown.
F. Place the rope gasket in the gasket groove, on top of the
silicone.
g. Place the glass on the door. re-install the glass retainers.
NOTE: For replacement glass, size, thickness and specifica-
tions see “REpLACEMENTs” section.