W415-1426 / D / 05.22.19
EN
28
fi nishing
6.3 log
placement
2
A.
Place the back log (1) into the fi rebox, pushing it as
close to the fi rebox wall as possible and centered
onto the log support pan.
B.
Place the front log (2) on the ember screen lining up
the studs with the holes on the bottom of the log.
C.
Set the two cross-over logs (3, 4) into the pockets
provided on both the front and rear logs as shown.
PHAZER
TM
logs, glowing embers, and charcoal embers, exclusive to Wolf Steel Ltd., glow when exposed to
direct fl ame, and provide a unique and realistic glowing effect that is different in every installation. Use only certifi ed
PHAZER™
logs, glowing embers, and charcoal embers available from your local authoriez dealer / distributor.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pig-
ments burn in during the heat-activated curing process.
1
3
4
Fig. 1
!
WARNING
•
Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
•
Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
•
The logs are fragile and should be handled with care.
note:
Ensure the left support tab and the two right
support tabs are bent down to ensure the front
burner fl ame does not get sucked beneath the
front log.
note:
The ember screen frame has a minimal adjustment distance. When heating with propane, ensure the ember
screen is secured as close to the rear of the fi rebox as possible
(Fig. 1)
. T
his will ensure the log's distance from
the fl ames, and prevent excess carbon and soot.
When heating with natural gas, ensure the ember screen is
secured as close to the glass door as possible
(Fig. 2)
.
This will ensure the log's placement over the fl ames, and
create a glowing effect on the log.
Fig. 2
