W415-0924 / C / 09.28.12
11
EN
4.0 FINISHING
!
WARNING
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
RECONSTRUCTION.
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1 GLASS EMBER INSTALLATION
Glass front must be removed and the appliance must be mounted in
its fi nal location before the glass embers are installed.
Glass embers may have sharp edges, wear safety glasses and
gloves when handling.
A.
CLEAN GLASS MEDIA:
Glass media may have a fi ne oil
residue that needs to be cleaned prior to installation. Clean
the glass with mild dish soap, drain, rinse thoroughly and
dry before placing into the tray.
B.
Carefully place glass embers into the bottom tray on the
front of the appliance as illustrated.
C.
Apply an even layer of glass embers. Clean up any fallen
pieces and install glass front.
4.2 GLASS FRONT INSTALLATION
It is recommended that two people install this glass front onto the
appliance, Wear safety glasses and gloves when handling glass.
A.
Hold up the glass front onto the appliance (logo side out).
B.
Line up the four holes in the glass with the four threaded
holes in the appliance.
C.
Use the four supplied bolts with the supplied washers. Insert
the bolts through the glass front and into the threaded holes,
and fi nger tighten as illustrated.
!
WARNING
DO NOT OVER TIGHTEN THE BOLTS. OVER TIGHTENING THE BOLTS MAY RESULT IN GLASS
BREAKAGE.
