W415-0924 / C / 09.28.12
9
EN
Due to the many different materials used on different walls, it is highly recommended that you consult your
local builder before you install this appliance on the wall.
A.
Select a location that is not prone to moisture and is located at
least 36" away from combustible materials such as curtain drapes,
furniture, bedding, paper, etc.
B.
Have two people hold the appliance against the wall to determine
the fi nal location.
C.
With the appliance in position and level measure from the fl oor to
the top back edge as illustrated.
D.
The supplied wall mount bracket will be centered on the back of
the appliance. This bracket has four slots and three hooks on it.
The top slots will be located 1.250” down from the
previously measured top back edge. The bottom
slots will be 2.250” down from this edge.
E.
Mark out location, then mount the bracket onto
the wall using the four supplied screws. Ensure
the top slots measurement from the fl oor is 1.250”
lower then the top back edge measured earlier.
This bracket MUST have the hooks facing upward
and be level.
NOTE: It is strongly recommended
that the mounting bracket be screwed into the
wall studs where possible. If the wall studs
cannot be used, ensure that the supplied
plastic anchors are used to affi x the bracket to the wall and the bracket is adequately secured.
F.
With the wall mounting bracket installed have two people lift the
appliance up and insert the three hooks on the bracket into the three
slots on the back of the appliance.
G.
Check the appliance for stability ensuring that the bracket will not
pull free from the wall, causing the appliance to fall.
3.1.2 MINIMUM CLEARANCE TO COMBUSTIBLES
3.1.3 INSTALLING THE APPLIANCE
Side View
19.750” MIN
Body
Floor
26.500”
46.250”
MIN
Glass Front
Measurements are taken from the glass front.
Bottom 1"
Top
2
1
/
2
" to mantel
Sides
1"
Top
4
1
/
2
" to ceiling
Back
0"
Screws
Hooks
Wall Mount
Bracket
Back View
Slots
