Protruding SFFK01
Framing Kit min. 1/2”
from wall finish
The kit is used on the 530 engine fi tted with the SFFK01 Stonefi re Freestyle Framing Kit.
Note: The SFFK01 Framing Kit MUST protrude from the wall fi nish by at least 1/2 inch to install the 4-sided trim.
Note: The protruding extension baffl e assembled to the top pannel of the
SFFK01 must be removed
(if not already removed) in order to install this 4-sided trim.
Remove the extension baffl e by inserting a Philips screwdriver between the top pannel
and the baffl e itself as shown and remove the 2 screws. Then simply pull the baffl e out
of the gap and discard.
SFFT01
FREESTYLE 4-SIDED TRIM
INSTALLATION INSTRUCTIONS
For use
only
with
Valor Model 530 Heater fi tted with the SFFK01
4001764-02
TM
Installation
Once the wall around the fi replace is fi nished,
1. Release the four screws on each side of the
trim—two per side.
2. Slide the 4-sided trim onto the protruding
framing
ensuring that the convection baffl e
at the back of the frame is on top
.
THE
BAFFLE MUST TOUCH THE FREESTYLE
FRAME WHEN INSTALLED.
3. Center the trim on the fi replace and tighten
the four screws of the trim against the sheet
metal framing to maintain in position.
SFFT01 4-Sided Trim
Remove extension baffl e
screws
© 2009, Miles Industries Ltd. All rights reserved.
27-3/8” (69.4 cm)
1” (25.8 cm)
35-1/2”
(90.3 cm)
2-1/2”
(6.4 cm)
Overview
(Heater, Fronts, Frets and Door Kits sold separately)
REAR
CONVECTION
BAFFLE
ON TOP
AND TOUCHING
THE FREESTYLE
FRAME
Convection
Baffl e
Rear View
THE TOP CONVECTION BAFFLE MUST TOUCH THE FREESTYLE FRAME WHEN
INSTALLED.
