20
AD V AN C E D S E T T I N G S : R E B U I L D M E S H
Rebuilding the mesh is a request to redesign the internal Z-Wave database routing table to increase
communication efficiency and to accelerate device response times.
Each device or controller in the system not only captures and disseminates its own network data, but
also relays data for other nodes. Rebuilding the mesh should be performed after physical changes are
made to the network, such as after home construction projects, the addition of new appliances or wire-
less devices, or any other physical changes to the premises that might affect network communications.
Rebuild the mesh as follows:
1.
Tap
Rebuild Mesh
.
2.
In the
Confirmation
popup that appears, tap
OK
to proceed.
3.
When finished, the message
Rebuild Mesh Complete
ap-
pears.
4.
Tap "back" arrow (at the top left) to return to the
Z-Wave
Device Setup
screen. In the
Test
column, tap the button
(or "slide bar" for a dimmer) to test the devices as required.
Note:
Devices that cannot be added will be listed with an
asterisk in place of the first letter of the device name (for
example, "Dimmer12" will be displayed as "*immer12"). En-
sure the device is within range of the IBR-ZREMOTE or is
in a network whose devices support
Explorer Frames
(Z-
Wave protocol version 4.5 or greater). See the device in-
structions for range limits. If the device is within range but
is still unable to be included, remove / restore power to the
device, then repeat the inclusion process.
Advanced
Settings
Z-Wave
Device
Setup
